 |
|
 |
|
|
|
|
|
|
|
|
|
|
|
Communication and installation monitoring accessories for SOLCOMBOX | | Power Reduction Card (PRC)
The PRC option card enables the power output of PV installations to be reduced. The card transmits the ripple-control signals of the utility company to the controller of the inverter, providing a cost-effective method of complying with the new legal requirement to enable utilities to remotely control and limit the amount of power small andmedium-sized installations can feed into the grid.
Order reference:PRC
|
| | RS485 option card
RS485 option card for connecting several communication interfaces. An additional RS485 option card, for example, must be used for simultaneous use of master-slave data communication and a large display.
Order reference:OKRS485
|
| | Built-in analogue modem
Built-in analogue modem for remote retrieval of data from max. 32 inverters. The built-in modem card allows remote data retrieval without additional hardware and power supply, and with minimal power consumption.
Order reference:AMOI
|
| | USB/RS232 adapter
USB/RS232 adapter for reading out the data of an inverter connected to the RS232 port via the USB port of the PC. The set contains a USB extension cable.
Order reference: USB/RS232
|
| | Boot dongle
Boot dongle for installing new firmware with the software program SOLBoot over RS232.
Order reference: BD |
| | USB/RS485 adapter for wiring
USB/RS485 adapter for reading out the data of an inverter at the RS485 port via the USB port of the PC. The set contains a USB extension cable.
Order reference: USB/RS485-D
|
| | M12 connector, bulk
For setting up a master-slave network via the RS485 port or connecting the inverters to the SOLCOMBOX.
Order reference: STM12 |
| | Cable with one M12 connector, 1.5 m long
For setting up a master-slave network via the RS485 port or connecting the inverters to a remote data retrieval system. There is a connector at the one end.
Order reference: KSTM12/1-1,5m
|
| | Cable with two M12 connectors, 1.5 m long
For setting up a master-slave network via the RS485 port or connecting the inverters to a remote data retrieval system. There is a connector at each end.
Order reference: KSTM12/2-1,5m |
|
|
|
|
|
|
|
|
|
